Download EFN324 User Guide

Glossary
13.8.11
set connection_flow node_level
Use this command to define the quality of service. reset connection_flow node_level flow <*/[1­4]> resets the ingress flow values specified to the defaults.
get connection_flow node_level flow <*/[1­4]> gets the ingress flow values.
Syntax
set connection_flow node_level flow <1/2/3/4> priority <low/medium/high/highest> reliability <lowest/low/medium/high/highest> marking <none/0/1/2/3/4/5/6/7/Transparent>.
Arguments:
flow <1/2/3/4> ­ Insert the Flow_ID. Range 1 to 4.
priority <low/medium/high/highest> ­ Insert priority on the exit queue. Default is medium.
reliability <lowest/low/medium/high/highest> ­ Insert the reliability. Default is medium.
marking <none/0/1/2/3/4/5/6/7/transparent> ­ Insert the outgoing p­bit marking. Default is none.
Default Settings
reliability: medium
priority: medium marking: none
Command Usage
Quality of service parameters are defined for ingress flows. The connect vlan command (see section 13.8.6 on page 114) is used to select whether the QoS is based on p­bits or DSCP values. In the set connection_flow command, the QoS is defined for each p­bit or DSCP value of the flow. Same configuration (defined for the flows 1­4 using “set connection_flow node_level” command) is used for both DSCP and p­bit QoS criteria.