Download Geodimeter CU User Guide Part 1

Test Measurements
Note – If you consider it unnecessary to measure the tilt of
the horizontal axil, you can avoid this by answering NO to
the question.
Rotate the instrument to C2*, aim at a point which is at least
15grads above or below the horiz. plane. Press A/M in front
after each sighting.
Test
Tiltaxis
10:20
Face II: 0
*Servo: Rotate the instrument to C2. Wait for a beep and
aim at a point which is at least 15grads above or below the
horiz.plane. Press A/M in front after each sighting.
7
or
Press the A/M key in front. A beep is heard…
Press
in front
Note – Press A/M if you have a control unit at the front.
Make at least two sightings to the point, approaching from
different directions, and the press A/M in front...
Press
in front
Note – The same number of sightings must be made in
both C2 and C1.
Geodimeter CU General 5-33