Download A-Track DCC - User Guide - A

A-Track User Guide
in columns, running from top to bottom in each column, then moving rightwards to
the next column.
Single CVs can be added to a selected group (which may just consist of one other
selected CV) by clicking on the additional CV while either Ctrl (Control) key is held
down. Conversely, clicking on a selected CV while holding down either Ctrl key will
deselect that CV and remove its background (yellow) highlighting.
After clicking on at least one cell in the CV Value Grid, you can also select all CVs in
the displayed Grid by pressing Ctrl-A (hold down either Ctrl key then press the A
key). You can then deselect any individual CV by clicking on its location while
holding down either Ctrl key. Alternatively, you can first select those CVs you do
not want in the final selection by using the mouse in conjunction with either Ctrl
key, and then press Ctrl-I (either Ctrl key plus the I key) to invert the selection.
If you make an error in selecting a group of CVs, then simply click on any CV to
remove the unwanted highlighting and leave only the CV on which you clicked
highlighted. This last CV highlight can be removed by clicking on the highlighted CV
while holding down either Ctrl key.
The example below shows a group of CVs selected by a click on CV01 followed by a
click on CV46 with a Shift key held down, and then CV20 and CV26 removed from
the selection by clicking on them in turn with a Ctrl key pressed. Following
selection, a click on the Read/Verify CVs Action Button reveals the Read/Verify
Config’n Variables page –
You should also consider which decoder access Mode is to be used –
•
Paged is the most common mode (and most likely to work correctly), but is
also slow and may take up to 20 seconds to read the value of a single CV
Page 76 of 123
Version 4.3.2