Download Embedded Peripherals IP User Guide
Transcript
UG-01085 2014.07.24 Document Revision History 5-5 Document Revision History Table 5-2: Document Revision History Date Version Changes July 2014 2014.07.24 Removed mention of SOPC Builder, updated to Qsys December 2013 v13.1.0 Removed Cyclone and Cyclone II device information in the "EPCS Serial Flash Controller Core Register Map" table. December 2010 v10.1.0 Removed the “Device Support”, “Instantiating the Core in SOPC Builder”, and “Referenced Documents” sections. July 2010 v10.0.0 No change from previous release. November 2009 v9.1.0 Revised descriptions of register fields and bits. Updated the section on HAL System Library Support. March 2009 v9.0.0 Updated the boot ROM memory offset for other device familes in the EPCS Serial Flash Controller Core Register Map" table. November 2008 v8.1.0 Changed to 8-1/2 x 11 page size. No change to content. May 2008 v8.0.0 Updated the boot rom size. Added additional steps to perform to connect output pins in Cyclone III devices. For previous versions of this chapter, refer to the Quartus II Handbook Archive. EPCS Serial Flash Controller Core Send Feedback Altera Corporation
Related documents
Embedded Peripheral IP User Guide
Embedded Peripherals IP User Guide
Embedded Peripherals IP User Guide
Contents
accurange 3000 users manual
MiniMON29K User Interface: MONDFE
Thesis Paper - BRAC University Institutional Repository
BX-IV Dynamic Library User Manual
Building a C-based processor
“I hereby declare that I have read this thesis and in my opinion this
Embedded Peripherals IP User Guide
Lantronix DSTni-EX User's Manual