Download User's Guide Kona cutting plotter

User’s Guide Kona cutting plotter
Finetuning your cutter
EP O S readout
To be able to perform a contour job, the EPOS sensor needs to see the difference between
the media and the printed bounding box. When you have loaded a media and the
measurement of the bounding box fails, it is interesting to perform the EPOS read test. Via
this way you can see if the sensor is able to detect a contrast between the media and
bounding box.
Refer to
5.2.3
5
XY-distanceaccuracy
The XY - Distance Accuracy tests are developed to check the actual X-Y cutting distance with
the sent vector data.
Please follow the procedure below to make the test:
ͬ»° ïæ
Launch Mutoh’s CutServer.
ͬ»° îæ
Be sure that the cutter is connected with the Mutoh CutServer.
ͬ»° íæ
Select which test to perform.
ͬ»° ìæ
Select the appropriate connection and double-click.
ͬ»° ëæ
Load a roll or sheet with at least the measurements indicated in the dropdown
menu.
ͬ»° êæ
Load a knife.
ͬ»° éæ
A box is cut.
ͬ»° èæ
Peel out the box.
ͬ»° çæ
Measure the X length and Y width and enter them. Be sure to enter the values in
mm!
AP-75380 - Revision 1.3
131