Download A GUIDE TO BASIC MAINTENANCE & TROUBLESHOOTING

4. If the solution refuses to drain through or is very slow then remove the pad to flush / clean
out the tube that protrudes beneath this unit.
This is held in place by a single screw. If removed take care to position correctly when
replacing.
5. If you are concerned that there is a build up on the pad it is recommended that you remove
the metal mesh and foam pad completely from the plastic holder. This allows the inks to
drain directly down into the waste tank and does not require any weekly maintenance to
this unit.
A GUIDE TO BASIC MAINTENANCE & TROUBLESHOOTING TECHNIQUES
Page | 18