Download Installation Manual Turbec T100

Site preparation
4.1.2.6
Exhaust gases
Indoor installation:
The length of the exhaust pipe is important since the thermal expansion
requires an expansion bellow if there are no possibilities to route the exhaust
gases directly out through the wall. If the exhaust pipe before the wall is longer
than 2-3 meters, an expansion bellow has to be ordered. An extra pressure drop
of 2 KPa means 5% less power output.
All air ducts must be suspended properly in order not to add any extra forces to
the connection flanges.
Turbec recommends to insulate the exhaust pipe.
Note!
The following instruction is only valid for indoor installations that intend to
fulfil the standard, Stationary Engine Generator Assemblies UL 2200:
Exhaust piping and chimneys shall be designed, constructed, and installed in
accordance with the Standard for the Installation and Use of Stationary
Combustion Engines and Gas Turbines, NFPA 37.
Outdoor installation:
4.1.2.7
Hot water (T100 PH)
If other heat sources are connected to the same heating system, it is beneficial
with a close distance due to pressure drop, thermal losses in the distribution
system and installation costs.
4.1.2.8
Turbine room
The floor shall preferable have a smooth, but hard, surface. It is recommended
to use a oil resistant layer of epoxy, or equal, as the floor might be exposed to
smaller amounts of oil spillage.
Some mobile lifting devices need a minimum clearance of 100 mm between the
floor and the machine. If the floor is not completely levelled, or rough in its
structure, a higher clearance is necessary. The clearance must be in the range of
100 to 135 mm. See section 6. Mechanical installation and connection for further
information.
The noise level might have to be reduced if the T100 is located close to a
residential area. In doubtful cases, check with the local authorities.
4.1.2.9
42
Remote control system
The preferred solution is to use an existing telephone line for connection via
the remote system. It is also possible to arrange for network connection, or for
GSM connection.
Doc No. D12245-05
2.2T100s3_IM4_rev02.fm
For an outdoor installation, a chimney stack is included in the scope of supply.
It is mounted directly to the T100. No further equipment is needed.