1
Download User's Manual
Transcript
User’s Manual e6 225 Go to the Table Browser and find ‘Critical load group combinations’. Each line describes a possible combination of load groups. Load cases in checked load groups will be combined in critical combinations. By default the table contains only one line where all load groups are checked. New lines can be added by clicking the + button and check box states in existing lines can be changed but permanent load groups cannot be turned off. The program finds the extreme values according to the possible combinations. Load types The following loads can be applied to the elements: Load Concentrated Line (distributed) Edge (distributed) Dead load Temperature Fault in length Tension/Compression Forced support displacement Fluid Seismic Influence line Tensioning Moving Snow Wind Element node, beam beam, rib, plate, membrane, shell plate, membrane, shell truss, beam, rib, plate, membrane, shell truss, beam, rib, plate, membrane, shell truss, beam truss, beam support plate, shell node truss, beam beam,rib Beam, rib, plate, shell Beam, rib, plate, shell Beam, rib, plate, shell
