Download USER MANUAL - Digital Projection

Transcript
Digital Projection HIGHlite
660 Series POSITIONING THE SCREEN AND PROJECTOR
Installation and Quick-Start Guide
Positioning The Screen And Projector
Notes
1. Install the screen, ensuring that it is in the best position for
viewing by your audience.
Always allow the projector to
cool for five minutes before
disconnecting the power or
moving the projector.
2. Mount the projector, ensuring that it is at a suitable distance
from the screen for the image to fill the screen. Set the
adjustable feet so that the projector is level, and perpendicular
to the screen.
The dimension drawing below shows the positions of the feet for
table mounting, and the fixing holes for ceiling mounting.
1
Four adjustable feet
2
Six M6 holes for ceiling mount
The screws should not penetrate more than 15 mm
(0.6 in.) into the body of the projector.
Ensure that there is at least
30 cm (12 in.) of space between
the ventilation outlets and any
wall, and 10 cm (4 in.) on all other
sides.
Do not stack more than three
projectors.
1
1
2
2
2
2
Do not tilt the projector more than
±12° from side to side when in
use, as this may cause serious
lamp failure, damage the lamp
module and cause extra cost on
replacement.
±12°
Rev G July 2014
2
2
1
1
360°
11