Download User Manual - Sound

Transcript
3.2.2. Rear panel
All connections are done on the rear panel of the codec. The characteristics of the interfaces and
layout of the sockets are detailed in chapter 6.1, Characteristics of interfaces.
The following elements are available (numbers such as [17] refer to the following Figure 4 ² Rear
panel):
Mains power socket [17]
This is an IEC type power socket. The unit starts up as soon as power is applied.
See details in 6.1.17 and 6.4 (Power supply).
DC 12V power socket [16]
This 4 pin male XLR is optional. See details in 6.1.18, DC power supply (option).
Audio inputs/outputs
x
Analog inputs/outputs [9]: at the input, plug the audio cables into the female XLR sockets. At
the output, plug the audio cables into the male XLR sockets. ,QPRQRPRGHRQO\´$µFKDQQHO
is used.
x
Digital inputs/outputs [1]: a digital input (mono or stereo) in AES/EBU format (or SPDIF) can
be connected on the female XLR socket, and a digital output in AES/EBU format is available
on a male XLR socket.
x
It is possible to select which input (analog inputs or digital input) is fed to the encoder for
transmission. On the receiving side, the decoded signals are output both on the analog and
digital outputs.
Ethernet interface [13]
This socket is a 100BaseT/10BaseT port, used for audio transmission over IP and/or for remote
controlling the unit. This RJ45 socket is devised for a QRUPDO´VWUDLJKWµFDEOHWRDQ(WKHUQHWKXERU
switch. The two integrated LEDs show the presence and activity of the network (green LED) and the
interface mode: half-duplex (yellow LED off) or full-duplex (yellow LED on).
The configuration of the interface is described in 3.4, Initial setup of the Ethernet interface.
ISDN 1 and POTS socket (marked ´,6'13276µ) [5]
This RJ45 socket allows the connection to the ISDN, for the product versions which include this
capability. The wiring is for connecting an S0 (BRI) ISDN line using a standard RJ45 cable.
Only this socket has to be used when only one line is needed (links using one or two B channels),
which includes the operation in double ISDN codec mode.
For the units equipped with the PSTN/POTS option, this socket is also used to connect the POTS line.
For this you can use the adapter cable provided with the POTS option: this adapter splits on two
sockets the ISDN 1 line and the POTS line:
x
x
RJ45 socket to get the ISDN 1 access;
RJ11 socket to connect the POTS line: you must plug here a cable from the POTS wall
socket1 and terminated with a RJ11 plug.
Refer to 6.1.8 for more details on the pinout for the ´ISDN 1µ socket and the adapter cable.
1 Whose type depends on the country and the building wiring
SCOOP 5 - User Manual
29