Download User Manual

GSK983M Milling CNC System User Manual (Volume II: Operations)
Pressing the DIAGNOSIS soft function key displays 64 diagnostic data.
Pressing the page ↑ or ↓ and cursor ↑ or ↓ to display the desired diagnostic data.
4.4.27.3 Direct entry of measured workpiece origin offset
The coordinates of the relative coordinate system that offsets at the workpiece origin and is
indicated by the LCD screen may be set as workpiece origin offset. With the function the
relative coordinate system is cleared away at the reference point and the machine is moved
to the workpiece origin by manual. Now the coordinates of the relative coordinate system
may be set as workpiece origin offset. In this way it is easy to set the workpeice origin offset.
(1)
Operating procedures
The relative coordinate system may be cleared away and workpiece origin offset set on the
workpiece origin offset page of the LCD through the following procedures.
(a) Delete the relative coordinate system
Pressing the X and SHIFT keys deletes the relative coordinate system of axis X (this
operation accordingly applies to axes Y and Z as well as the 4th and 5th axes).
(b) Set workpiece origin offset
Press the X and INPUT keys after moving the cursor to the required workpiece offset
number. Then the coordinates of the axis X in the corresponding coordinate system is
set as the axis-X workpiece origin offset of the selected workpiece offset number.
(This operation accordingly applies to axes Y and Z as well as the 4th and 5th axes
Note: When the
system blinks.
X
key is pressed in steps (a) and (b), the X of the relative coordinate
4.5 Position indication through position display unit (available upon customer’s request)
The position display unit indicates the actual position. The position display reset buttons are
connected to the position display unit. Each button corresponds to one axis. The position
66