Download JNEye User Guide

UG-1146
2015.05.04
Analysis
3-15
Figure 3-14: Channel Characteristics of Victim and 2 FEXT Channels (with Data Cursor Enabled)
Start the channel simulation by clicking Simulate in the lower right corner of the JNEye Control Module.
The JNEye Simulation Engine simulates all the models and generates eye diagrams at test points and
inside the receiver (after CTLE and DFE).
A goal of this tutorial was for JNEye to automatically find the optimal link setting for both transmitter and
receiver. In the simulation time, the progress bar flashes, indicating the JNEye Simulation Engine is
exploring the solution space. The link performance and result of the final setting is shown in a JNEye Data
View.
At TX output, which is located after the Altera Stratix V GX transmitter output pin (after the TX package
model), the results are shown in the following figure. JNEye found the optimal TX-FIR setting: Pre-tap 1
= –4, Post-tap 1 = 2, and Post-tap 2 = 0. The configured transmitter generates ~0.83 UI of jitter at BER =
10-12. This set of TX outputs is measured with an ideal clock. In addition to the transmitter’s intrinsic
jitter, the reference clock’s jitter and noise (recall that external reference clock phase noise and spurs in
this simulation are filtered by the Stratix V GX ’s PLL) are seen here.
Tutorial: PCI Express 8GT
Send Feedback
Altera Corporation