Download M22 / M23 / M23G AT Command User Guide

<Value 0>, <Value 1>, …<Value 30>: 0 - 65535
The FIR coefficient value.
Informative examples
-Initial the HyperTerminal
-Initial the MS
-AT Command
AT$AUPATH=3,1
$AUPATH: 1
OK
/* Set FIR coefficient */
AT$AUFIR=65514, 65424, 65381, 65389, 65399, 194, 713, 593, 444, 1416, 1206,
65526, 1481, 4031, 63490, 16384, 63490, 4031, 1481, 65526, 1206, 1416, 444, 593, 713,
194, 65399, 65389, 65381, 65424, 65514
OK
2.6.9 Audio Uplink FIR $UPFIR
Table: $UPFIR parameter command syntax
Command
$UPFIR =<value 0>, <value 1>,
<value 30>
$UPFIR=?
Possible response(s)
….,
OK
$UPFIR: (list of supported < value >)
OK
$UPFIR?
$UPFIR: <value 0>, <value 1>,
<value 30>
….,
OK
Description
This command is used to configure the FIR filter coefficient which the uplink
(audio microphone) signal is be filtered. Note that this command has to be used
after audio path is configured by AT$AUPATH.
©2006 BenQ Corporation.
AT Command User Manual
Confidential Property
252
Version: 1.7.7 20/09/2006