Download MSM6636 USER'S GUIDE

Transcript
14.5
Off Node Process
Depending on the application, some units may not be used for LAN construction. The following
is an example of how to process a unit which is not used (off node process).
If Unit D is not used in the following LAN configuration, the power of Unit D is usually shut off, but
the electric current path from the LAN bus to the off node unit still exists.
When BUS (+) becomes dominant status (BUS (+)=5V), electric current flows from the bus driver
of the unit, which made BUS (+) dominant status, to the internal protective diode of MSM6636.
This is one such electric current path. Another path is the path from pull-up resistance of BUS
(–) to BI– terminal input pull-up resistance on-board MSM6636 of the off node. Figure 14-17 shows
these electric current paths.
To prevent this electric current from flowing, be certain to shut the unit power OFF, and to
disconnect the unit from the LAN bus.
14-12