1
Download Command Line User's Guide
Transcript
Chapter 29: Rapid Spanning Tree Protocol (RSTP) Commands migrationcheck no, off, false The port is not an point-to-point port. The parameters are equivalent. are equivalent. autoupdate The port’s status is determined automatically. This is the default. Enables and disables migration check. The purpose of this feature is to change from the RSTP mode to the STP mode if STP BDPU packets are received on the selected port. When you enable this option, the bridge will send out RSTP BPDU packets from the selected port until STP BPDU packets are received. The port will remain in the RSTP mode until it receives an STP BPDU packet. The options are: yes, on, true Enable migration check. The options are equivalent. no, off, false Disable migration check. The options are equivalent. Description This command sets a port’s RSTP settings. Examples The following command sets the port cost to 1,000,000 and port priority to 224 (increment 14) on port 4: set rstp port=4 portcost=1000000 portpriority=14 The following command changes ports 6 to 8 so they are not considered edge ports: set rstp port=6-8 edgeport=no AlliedWare Plus Command Syntax spanning-tree spanning-tree spanning-tree spanning-tree path-cost path-cost priority priority edgeport|portfast link-type point-to-point|shared Note The EDGEPORT and PORTFAST parameters are equivalent. Mode Port Interface mode 544 Section V: Spanning Tree Protocols
