Download 8pre User Guide for Windows

SETTING UP FOR SMPTE TIME CODE SYNC
Use this setup if you have:
In summary, the 8pre system can resolve directly to
SMPTE time code. It can also generate time code
and a time base, under its own clock or while
slaving to time code. Therefore, the 8pre can act
both as an audio interface and digital audio
synchronizer. You can use the 8pre to slave your
audio software to SMPTE as well, as long as your
software supports ASIO2 sample-accurate sync,
which is the means by which the software follows
the 8pre. The accuracy may not be sampleaccurate, but in most cases it will be very close.
✓A SMPTE time code source, such as a multitrack tape deck.
SMPTE time code
source
✓Host software that supports sample-accurate sync.
This setup provides:
✗ No sample-accurate locating.
✓Continuous sync to SMPTE time code.
✓Sub-frame timing accuracy.
✓Transport control from the SMPTE time code source.
Choose SMPTE as the clock source in
the MOTU Audio Setup. This setting
can also be made in the MOTU SMPTE
Setup software (shown below).
audio cable bearing LTC
(Longitudinal Time Code)
In Cubase SX, go to the Sync Setup window and choose the ASIO Audio Device option.
Any analog input
8pre interface
When lockup is achieved, the CLOCK light illuminates and the TACH light blinks once per second.
FireWire cable
Windows computer running Cubase or
other sample-accurate ASIO2 software
Launch the MOTU SMPTE Setup and specify the SMPTE Source, which is
the input receiving the SMPTE time code. Also, confirm that the Clock
Source/Address is SMPTE/SMPTE.
Figure 12-3: Connections for synchronizing the 8pre directly to SMPTE time code.
62
MOTU SMPTE SETUP