Download Radio Explorer User Manual

65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: [email protected] ,Web: www.devabroadcast.com
BAND ANALYZE
“BAND ANALYZE” - WHAT IS IT ALL ABOUT?
First step of Analyze Process is defining the “zone for analyze”. Selecting the reference level
(See [3]) defines the bottom of the zone. Top is defined by the maximum measured level. Left and
Right edges of the zone are defined by the scanned range (See [8]).
Next, after the zone is defined all the peaks within are located (see “Peak Find Methods” on
page 49) and Analyzing Process may start. Before actual analyzing only frequency for each peak is
known (and shown above), which defines list of frequencies to be observed/analyzed.
By pressing the Start Analyze button Analyze process is started. Every peak is analyzed for
a period of few seconds (“Band Analyzer Settings” - Observe Time) and report is generated for
frequency and RDS data (if any available - PI/CALL and PS are shown).
The report from the Analyze Process is visible as “Balloons” above every analyzed peak. More
detailed information can be found under the Band Info Table.
The Analyze Process can be stopped at any time.
Right after the analyzing is finished/stopped, the tuner retunes to the frequency before the start
of Analyze Process.
- 48 -