Download USER'S MANUAL

SECTION 2
Installation, Connections, and Wiring
Mounting Cables
Use the connectors provided with the ID Controller.
Manufacturer
Cable
RS-422 lines
---
Connector
Crimp terminals
Model
Remarks
---
0.5
mm2
MC1.5/5-STF-3.5
When connecting 2 lines
to each terminal
---
AI0.5-8WH
Phoenix Contact
Crimping Tool
---
AI-TWIN2 × 0.5-8WH
---
CRIMPFOX UD6
---
SECTION 2 Connection and Wiring
When connecting 1 line
to each terminal
(equivalent to AWG 20)
1. Attach the crimp terminals to the sections of the cable where the
sheath has been stripped.
2. Make sure the connector is facing the right direction and insert each
crimp terminal into the correct connector hole.
Connector: MC1.5/5-STF-3.5
(manufactured by Phoenix Connector)
3. Firmly tighten the connector cable screws.
Recommended tightening torque: 0.22 N·m
Use a small flat-blade screwdriver with a uniform thickness. Do not use a standard screwdriver with a tapered end. A standard screwdriver will not fully
insert into the hole.
Small flat-blade screwdriver
with a tip of uniform thickness.
4. Once all of the cables have been connected to the connector,
attach the connector to the ID Controller.
Align the cable connector with the connector on the ID Controller. Hold the connector body and push the connector firmly into place, and then tighten the connector
lock screws.
Recommended tightening torque: 0.4 N·m
Lock screws
Removing the Connector
Completely loosen the two lock screws, hold the protruding part of the connector, and pull straight out. If the connector
is difficult to remove, press on the ID Controller while pulling on the connector.
Do not connect cables to the connector after attaching the connector to the ID Controller.
RFID System
User’s Manual
39