Download Valhall Operators Manual

Transcript
Proc. Order
Determines the sequential processing order of Curves and
Black/Gamma/Gain/Lift/Video Gain controls.
Black-Gamma-Gain > Curves
This is the preferred mode when
Curves are to be used as a creative
effect.
Curves > Black-Gamma-Gain
This is the preferred mode if Curves
are to be used as a set-up to correct
e.g. camera imbalances, typically in
the Base layer.
This control is found on the Processing tab of each primary layer.
Input
The Input Selection control determine from where each layer gets it
input from:
Original Input
The layer get its input unprocessed by
previous layers
Base Layer Output
The layer get its input from the output of
the Base Layer
Previous Layer Output
Layer 2 get its input from the output of the
Layer 1
These controls are found on the Processing tab on primary layer 1 and
layer 2.
Hue/Sat Clip Mode
Determines the colour space in which Hue and Saturation should be
applied, either HSY (Y=Luminance) or HSL (L=Lightness). Luminance
and Lightness are two commonly used but different ways of
representing the brightness in the picture.
Legal RGB
Determines whether the output from the Hue and Saturation processing
should be legalized in the RGB colour space or not before being passed
on to Black/Gamma/Gain and Curves processing.
Layer Clip
Enables independent upper and lower clip separately for Y and RGB.
Can be used for legal clipping or for artistical effects.
All controls are found on the Curves tab on each primary layers.
174 • ACP 2.0, Advanced Colour Processor
User's Manual