Download CCM 1200 OPERATING INSTRUCTIONS

Schleuniger CCM 1200
37
Replacing the feed roll V-belts
Switch the master switch off. Remove the mains plug from the power supply. The
following work should only be carried out by specially trained personnel (Schleuniger
representatives, the user’s trained specialist personnel).
• Remove the cover for the feed
roll drive. This is the cover next
to the control panel with the four
socket head screws (SW 2.5).
Gears
feed rolls
Belt tightener,
feed rolls
Twin power V-belt
• Loosen the “drive motor” belt
tightener slightly. After you have
pushed the belt tightener down
you can remove the smaller Vbelt (belt drive motor Fig 12).
• Loosen the “drive motor” belt
tightener slightly. After you have
pushed the belt tightener down
you can remove the double cog
belt (twin-power belt).
• Fit and set the tension for the
new double V-belt.
Belt, motor
drive
Belt tightener
drive motor
Cover with
ejection shaft
Figure 12. Replacing the feed roll V-belts
In order to set the correct tension for the double V belt the upper feed roll must be in the
bottom position. So turn the upper feed roll using the T-grip, downwards until it almost
touches the bottom feed roll.
• Now slide the belt tightener upwards until the required tension is achieved, then tighten the
screw.
• Fit and set the tension for the smaller V-belt.
• Fit the cover.
• Insert the mains plug into the power supply.
+
The procedure for replacing the “drive motor” V-belt can also be seen from the
description above.