Download WEIGHT INDICATOR USER MANUAL - net

TPWATEX
MODE WITHOUT HYSTERESIS
One enters just one set point value, which corresponds to the enabling threshold, both with the one for the disabling the
output.
To enter the set point value, follow the procedure below:
(example refered to output 1)
Press ENTER for three seconds à
Sb 1 .on à press ENTER à 000000 à enter
the set point value à press ENTER to save the value.
Do the same for all the outputs which functiong without hysteresis.
Once the programming is finished, press the C key to return to weighing.
NOTES: the value must be ≤ than the scale capacity.
MODE WITH HYSTERESIS
One enters two set point values, an enabling one and a disabling one of the output:
- disabling set point: when the gross weight value is reached and goes below this value, the output is disabled.
- enabling set point: when the gross weight value reached and goes above this value, the output is enabled.
OUTPUT
LEVEL
High
(+5Vdc)
low (0 Vdc)
Sb1 oF
WEIGHT
Sb1 on
In order to enter the set point values, follow the procedure below:
(example refered to output 2)
Sb 2.oF à press ENTER à 000000
the disabling set point value à press ENTER to save the value à
Sb 2.on à
press ENTER à 000000 à enter the enabling set point value à press ENTER
Press ENTER for three seconds à
to save the value.
Do the same for all the outputs which function with hysteresis.
Once the programming is finished, press the C key to return to weighing
28
à enter