Download USER MANUAL - memo
Transcript
Technical Specifications 7.4 Upgrading Firmware To install the latest Kramer firmware version on a VP-724DS unit, connect the COM port on your PC to the RS-232 port on the VP-724DS unit, as section 5.1 describes, and go to the Kramer Web site at: http://www.kramerelectronics.com. 8 Technical Specifications Table 6 includes the technical specifications: 1 Table 6: Technical Specifications of the VP-724DS VIDEO: 2 x composite video 1 Vpp/75 Ω on RCA connectors; 2 x Y/C (s-Video) 1 Vpp (Y), 0.3Vpp (C) / 75 Ω on 4 pin connectors; 1 x Component (Y, Pb/Cb, Pr/Cr) on RCA connectors; 2x VGA (VGA/SVGA/XGA/UXGA) on HD15F connectors; and 1x DVI connector AUDIO: 2 x stereo audio on terminal block connectors (CV); 2 x stereo audio on terminal block connectors (YC); 2 x stereo audio on terminal block connectors (VGA); 1 x stereo audio on a terminal block connector (component); and 1 x stereo audio on a terminal block connector (DVI) VIDEO: 1 x VGA/SVGA/XGA/UXGA as well as additional modes: 480p, 720, 1080i on Outputs: an HD15F connector AUDIO: 1 x stereo audio on a terminal block connector Output VGA (640x480), SVGA (800x600), XGA (1024x768), SXGA (1280x1024), UXGA Resolutions: (1600x1200), 1024x852, 1024x1024, 1366x768, 1365x1024, 1280x720, 720x483, 852x480, 1400x1050. Also supports 480p, 720p, and 1080i, as well as a user definable output mode Control: Front panel buttons/ OSD, IR remote control, RS-232 on a DB-9 connector Additional Controls: Different vertical refresh rates, ProcAmp control, output image scaling and aspect ratio change Firmware: Frame freeze, digital zoom 4X, PIP (video-in-graphics or graphics-in-video, in sizes of up to half a screen, located anywhere on the screen), Flesh tone (special color processing), Gamma setting H Frequency: 15.63~90kHz V Frequency: 50~100Hz Computer Resizing: Auto-resizing to panel pixel number RGB Video Signal: RGB, 1.0 Vpp, 75 Ω Inputs: RGB Sync Signal: Audio Input/Output Voltage: Plug and Play: De-interlacing: Film mode detection: Power Source: Dimensions: Accessories: Weight: Separate H/VTTL, composite sync, analog 0~0.5 Vrms DDC1 / DDC2B Adaptive and pixel based 2:2 / 3:2 pull down reverse 100-240 VAC, 50/60 Hz, 30VA automatic power supply 19" (W), 9.3" (D) 1U (H) rack mountable2 IR remote control, power cord3 3 kg (6.6 lbs.) approx. 1 Specifications are subject to change without notice 2 When installing a Kramer machine on a closed or multi-unit rack assembly, be aware that the operating ambient temperature of the rack environment may be greater than room ambient. In particular, take care that there is sufficient air flow. (Refer to the "Operating Conditions.pdf" file on our Web site at http://www.kramerelectronics.com (click "FAQs" in the Technical Support section)) 3 We recommend that you use only the power cord that is supplied with this machine 36 KRAMER: SIMPLE CREATIVE TECHNOLOGY