Download User Manual

E-15
Using MC Software 1.0.1.2, Motor Controller to Display EOR message failure
E-18
Using MC Software 1.0.4.2, Motor Controller did not run all steps (mainly affects Prevailing Torque)
E-1B
Using MC Software 1.0.1.2, Battery Cell Fault (detected by Motor Controller)
E-1C
Using MC Software 1.0.1.2, Low Battery Fault (detected by Motor Controller)
E-1D
Using MC Software 1.0.1.2, Critical Battery Fault (detected by Motor Controller)
E-1E
Using MC Software 1.0.1.2, Motor Controller is shutting down
E-1F
Using MC Software 1.0.1.2, Wakeup Code received (but not expected)
E-81
The configuration ID in the Motor controller’s EOR did not match the currently selected configuration
10-01
Configuration Page Update from Communication interface (USB or Wireless)
10-02
Tool Locked by Communication Interface (USB or Wireless)
10-03
Tool disabled by Communication Interface (USB or Wireless)
10-04
Configuration Selected by Communication Interface (USB or Wireless)
10-05
Gang Advanced by Communication Interface (USB or Wireless)
10-06
Gang reset by Communication Interface (USB or Wireless)
10-07
Configuration advanced by Communication Interface (USB or Wireless)
10-08
Configuration Reset by Communication Interface (USB or Wireless)
10-09
SPI Memory erased by Communication Interface (USB or Wireless)
10-0A
Tool Reset by Communication Interface (USB or Wireless)
10-0B
Factory calibrations restored by Communication Interface (USB or Wireless)
10-0C
Cycle log cleared by Communication Interface (USB or Wireless)
10-0D
Event log cleared by Communication Interface (USB or Wireless)
10-AA
Time updated by Communication Interface (USB or Wireless)
20-01
Complete Tool memory reset to defaults
20-02
Tool reset configuration to Defaults
EE-E0
RF Protocol Error - RF Message Packet too small
EE-E1
RF Protocol Error - RF Packet too long
Motor Status Code description;
Bit Position
1
2
3
4
5
6
7
8
9
10
11
12
13
14
16
17
19
20
25
48619696_ed1
Fault Description
Battery
Invalid Hall State
I2T
Motor Stall
Over Current
Over Temperature
Current Offset Fault
Shunt Cal
Torque Offset Fault
Transducer Fault
Step Time Out
Configuration Timeout
Over Torque
Over Angle
Under Torque
Under Angle
Early Trigger Release
Watchdog
Missed Run Steps
65