Download User Manual

Opertating temperature
－25
＋85
℃
Storage temperature
－40
＋125
℃
4.I2C Description
Clock and Data Conventions
Data states on the SDA line can change only during SCL LOW. SDA state changes during
SCL HIGH are reserved for indicating start and stop conditions. Refer to Figures 1 and 2.
Start Condition
All commands are preceded by the start condition, which is a HIGH to LOW transition of SDA
when SCL is HIGH. The CR030 continuously monitors the SDA and SCL lines for the start
condition and will not respond to any command until this condition has been met.
Stop Condition
All communications must be terminated by a stop condition,which is a LOW to HIGH transition
of SDA when SCL is HIGH. The stop condition is also used by the CR030I2C to place the
device in the standby power mode after a read sequence. A stop condition can only be issued