Download DigitroniK Digital Program Controller DCP32 User's Manual

Chapter 6. OPERATION
6-4
External Switch (RSW) Operations
■ External switch (RSW) inputs
In all, the DCP32 is provided with 12 external switch inputs. Each of these inputs
are differentiated by RSW1, RSW2 and so forth up to RSW12. On models whose
option 2 model No. is “0”, only inputs RSW1 to RSW4 are mounted.
(RSW: external switch input)
● External switch input types
The functions of RSW1 to 4, and RSW8 to 12 are fixed.
The functions of RSW5 to 7 are selected by setup data C71 to C74.
External
Switch No.
Function
Detection Method
RSW1
RUN
Rising edge
RSW2
HOLD
Rising edge
RSW3
RESET
Rising edge
RSW4
ADV
Rising edge
RSW5
Selected by setup from the following functions
RSW6
FAST
Rising edge
RSW7
PV start (using PV1)
Rising edge
PV start (using PV2)
Rising edge
AUTO/MANUAL (CH1)
Rising/falling edge
AUTO/MANUAL (CH2)
Rising/falling edge
AT start/stop (CH1)
Rising/falling edge
AT start/stop (CH2)
Rising/falling edge
G.Soak cancel by OR conditions
Status
G.Soak cancel by AND conditions
Status
Direct/reverse action switching (CH1)
Status
Direct/reverse action switching (CH2)
Status
RSW8
Program No. selection
Weighting 1
Status
RSW9
Program No. selection
Weighting 2
Status
RSW10
Program No. selection
Weighting 4
Status
RSW11
Program No. selection
Weighting 8
Status
RSW12
Program No. selection
Weighting 10
Status
Note
• With “G.Soak cancel by OR conditions,” G.Soak standby is canceled when the
external switch turns ON, or when the PV is within the G.Soak width setting.
• With “G.Soak cancel by AND conditions,” G.Soak standby is canceled when the
external switch turns ON and the PV is within the G.Soak width setting.
• With “direct/reverse action switching (CH1),” direct/reverse action follows the
setting of setup data C01 when the external switch turns OFF. When the
external switch turns ON, action is opposite to the setting of setup data C01.
• With “direct/reverse action switching (CH2),” direct/reverse action follows the
setting of setup data C21 when the external switch turns OFF. When the
external switch turns ON, action is opposite to the setting of setup data C21.
6-11