Download User Manual - TWK

Transcript
10. RS-Networx for DeviceNet
Fig. 10.11 Store parameters in EEPROM
10.7 Load parameter default values
All encoder parameter default values can be restored with the command „Restore“ service code 21dec of the position
sensor object.
Mark the encoder in the bus and switch, in the case of an existing on-line connection, to the Class Instance Editor submenu via the Device main menu item. Under Data Address, specify Class 0x23 (Position Sensor Object), and select the
Restore (0x15) service. Then actuate the Send button.
The default values take effect after switching the power off/on.
Fig. 10.12 Load parameter default values
- 42 -