Download User Manual

Nucleus Freedom Sound Processor
Accessories and the telecoil
When you are using an accessory with your Sound Processor,
it is possible to change to use the in-built telecoil or the
microphone only setting, with the accessory still attached to
your Sound Processor. For example, if you are using your TV/
Hi-Fi cable and then wish to use a telephone with a telecoil
induction loop, you can switch to the in-built telecoil setting
while the TV/Hi-Fi cable is still attached.
This set of actions is part of a cycle. Each time you push both
the Increase and Decrease buttons at the same time, for a
few seconds, you move on to the next setting. Starting from
where you can hear the accessory, by pushing the buttons
you move to the in-built telecoil, then to the microphone
Sound
Processor on
Plug in
accessory
Push Increase and Decrease
buttons at the same time for a few
seconds to start the accessory
Accessory
Push Increase and
Decrease buttons
at the same time
for a few seconds
In-built
telecoil
Push Increase and Decrease
buttons at the same time for a
few seconds
50
Push Increase and
Decrease buttons
at the same time
for a few seconds
Microphone
only