Download User Manual - Stemmer Imaging

User Manual
Bobcat-640-GigE&CL Camera
2.2. Bobcat-640-GigE & CL Specifications
The camera specifications are listed in Table 2-2.
Feature
GigE
CL
Unit
Imaging performance
Frame rate
Hz
100
Window of interest
Yes (minimal window: 32x4)
Exposure time range
1-40000
(1)
µs
Gain (in High Gain mode)
1.28
electron/ADU
Gain (in Low Gain mode)
Camera Read Noise Low
(4)
Gain
Camera Read Noise High
(4)
Gain
Dynamic Range Low Gain
16.2
electron/ADU
400
electrons rms
120
electrons rms
68
dB
Dynamic Range High Gain
Readout mode
On-board image
processing
A to D conversion
resolution
Interfaces
Image acquisition and
Camera control
Trigger
Trigger-in delay
Trigger-in jitter
-
56
Integrate Then Read (ITR)
Integrate While Read (IWR)
Imaging correction (fixed NUC for BobcatGigE, TrueNUC for Bobcat-CL),
Auto-Gain and Offset
Auto-Exposure (Only for Bobcat CL)
Trigger possibilities
14
GigE Vision
dB
bit
Camera Link
In or out via SMA or CLCC1
1.3 µs rising and falling
3.1 µs rising edge (SMA
edge (CC1 trigger)
(5)
3.1 µs rising edge (SMA
trigger)
(5)
3.3 µs falling edge (SMA
trigger)
(5)
3.3 µs falling edge (SMA
trigger)
(5)
trigger)
± 0.05
In or out via SMA
µs
µs
Power Requirements
Input Voltage
Power consumption (2)
4
Physical characteristics
Dimensions (3)
55x55x81.7
Camera weight (3)
334 without lens
Environmental specifications
Operating case
temperature
Storage temperature
Vibration
Shock
12±10%
2.8
55x55x72
285 without lens
V
W
mm
g
-40 to 70
°C
-45 to 85
°C
4.3G (20 to 1000 Hz)
G
40G (11ms, half-sine profile)
G
3
Company confidential.
This document is the property of Xenics. It may not be reproduced – completely or partially – or passed to a third party
without written permission from Xenics.
Xenics nv
Ambachtenlaan 44
BE-3001 Leuven  Belgium
T +32 16 38 99 00
F +32 16 38 99 01
www.xenics.com
Doc Ref: ENG-2012-UMN020
Issue: R002
Date: 31/03/2014
XF-104_02/20-01-2012
Page 15 of 31