Download User's Manual

Transcript
Physics on Geometry, BRDF, Monitor Luminance, etc.
Figure 8.2: A sketch of a view along the street
The figure right above shows the measurement method done by Hoffmann and Nakata (independently of each other). Both of them set a car on the road with two lamps attached and a sensor
between them. Then they have measured the light being scattered back from the measuring points
on the surface (white dots; the LID is oversimplified just to illuminate the measuring zone on the
road). This method of measurement leads both to a good simplification but to a large restriction
of the validity area too. This type of BRDF does only work when observing the scattering process
from a position very close to the driver view.
The corresponding parameters and used values in von Hoffmanns dissertation (in chapter 6) are:
ho = hS = 0.65m and hi = hA = 1.13m.
8.2.2. Lommel-Seeliger
The Lommel-Seeliger is a BRDF mostly used in astronomical tasks for description of planet surfaces.
It has the form f(ϑi, ϑo) = R/[π·(cosϑi+cosϑo)].
Please refer also to http://orca.phys.uvic.ca/~tatum/plphot/plphot01.pdf.
For the intensity mapping at first the normalised luminance is calculated, here the maximal luminance
Lmax is involved: Ln = L/Lmax. The light intensity function for Munsell is an approximation to the
light intensity component of the Munsell Color Order System. The following listing contains a corresponding source code:
51