Download CLIPSTER Edit Tool User Guide (Version 3.2)

CLIPSTER Edit Tool User Guide
Column
Search criteria
Description
Details the search criteria that was selected during an autoconforming (see section “Conforming” on page 8-14). It is the same setting as the
respective Video or Audio source TC setting
of the autoconforming dialog. By changing this
entry you can change what should be searched
for. Depending on the selected ’Source type’,
this field either cannot be edited at all or provides different settings possibilities. In addition
to the settings already described in section
“Configuring the Autoconforming” on
page 8-16 you can select here for video clips
the following:
Start frame This setting is similar to File
number as TC. You can use
it if there is no direct connection between file numbers and
EDL timecodes. With this setting you can specify a start
frame number that should be
identified as the source inpoint
(see below). The actual search
will be performed as with
File number as TC.
This setting can also be made on the
tab EDL Reels. There you can assign a
start frame number for a complete reel
(see section “The Tab ’EDL Reels’” on
page 8-37).
When an autoconforming is performed
for this event, a manually adjusted setting will be overwritten with the one of
the autoconforming.
Source TC type
8-36
If Source TC (in header) is selected in
’Search criteria’, you can select the type of timecode that should be used for the search with
this field. It is the same setting as made for an
autoconforming with source timecode (see section “Configuring the Autoconforming” on
page 8-16).