1
Download Menus Interface User's Guide
Transcript
AT-S63 Management Software Menus Interface User’s Guide 5->1->1->8->5. The Configure SNMPv3 Table menu is shown in Figure 139 on page 381. 2. From the Configure SNMPv3 Table menu, type 8 to select Configure SNMPv3 Target Address Table. The Configure SNMPv3 Target Parameters Table menu is shown in Figure 152. 3. From the Configure SNMPv3 Target Parameters Table menu, type 3 to select Modify SNMPv3 Table Entry. The Modify SNMPv3 Target Parameters Table menu is shown in Figure 153 on page 448. 4. To modify the Security Level, type 3 to select Set Security Level. The following prompt is displayed: Enter Target Parameters Name: 5. Enter a previously configured Target Parameters Name. Enter a value of up to 32 alphanumeric characters. The following prompt is displayed: Enter Security Level [N-NoAuthNoPriv, A-AuthNoPriv, P-AuthPriv]: 6. Enter the Security Level. Select one of the following Security Levels: Note The value you configure for the Security Level must match the value configured for the User Name in the Configure SNMPv3 User Table menu. See “Creating an SNMPv3 User Table Entry” on page 380. N-NoAuthNoPriv This option represents no authentication and no privacy protocol. Select this security level if you do not want to authenticate SNMP entities and you do not want to encrypt messages using a privacy protocol. This security level provides the least security. Note If you have selected SNMPv1 or SNMPv2c, N-NoAuthNoPriv is the only security level you can select. Section III: SNMPv3 451
