Download USER GUIDE V3.0

The monitors system encompass the following four sub-systems:
MONITOR SYSTEM
Soloing
Audio Monitors
Talkback
CONTROLS
There are three volume controls for Talkback, Monitor and Headphones, each has its own ON button.
Whenever one or more SOLO buttons is active the CLEAR SOLO button illuminates. Pressing this will clear
all the active solos on all layers.
Other control functions are accessed via the touchscreen. These are discussed in the text where appropriate.
CLEAR BUTTON
The CLEAR button is used to reset a large range of parameters to default conditions. The lists are shown
below.
Input bays: VCS/CHANNEL MODE/GLOBAL MODE
This uses interrogate/clear mode, i.e. press and hold one of the VCS/CM/GM buttons in the three lists below, all of the input channels, in that bay and selected bank, which have the selected parameter set will be
revealed by illuminating their SEL buttons. Pressing the CLEAR button will result in the described action.
VCS Buttons Action
48v
Switches 48v button selections OFF for all channels
Phase
Switches PHASE button selections OFF for all channels
Delay
Switches DELAY button selections OFF for all channels
Filters
Switches FILTER button selections OFF for all channels
Gate In
Switches GATE IN button selections OFF for all channels
Comp In
Switches COMP IN button selections OFF for all channels
EQ In
Switches EQ button selections OFF for all channels
LR
Switches LR button selections OFF for all channels
C
Switches C button selections OFF for all channels
LCR
Switches all LCR button selections OFF for all channels
Isolate
Switches ISOLATE button selections OFF for all channels
Soundcraft® Si Series User Guide V3 0410
Page 6 - 1