Download User's Guide «

7. System Overview
KBox C-101 – User’s Guide (Version 3.00)
Standard Front Panel:
The following interfaces are available with the KBox C-101:
 24VDC input power (X101)
 3x Gigabit Ethernet (X102, X103, X104)
 2x USB 3.0 (X105, X106)
 2x USB 2.0 (X107, X108)
 DisplayPort (X109)
 SD Card slot (without X numbered slot)
 RS232 serial (X110)
 Buttons with corresponding LEDs:
• RSQ (rescue)
• PWR (power)
 LEDs:
• GP1 to GP4 (general purpose LEDs)
• THERM (thermal status)
• DRIVE (SSD/HDD drive status)
• SD (SDHC/SDXC status)
• WD (Watchdog status)
Standard Baseboard - Onboard and System Expansion Capabilities:
• up to 2x SATA and power connector (for internal or removable devices, depending on the KBox C-101 configuration)
• 2x mSATA sockets
• 2x Mini PCIe x1 sockets (one socket is on the top side, the second one on the bottom side of the baseboard)
• 1x PCIe x8 socket for expansion via riser cards:
 up to 2x PCIe x4 sockets on riser card (depending on the KBox C-101-2/-1 configuration) or
 1x PCI (32 bit) and 1x PCIe x4 sockets on riser card (available for KBox C-101-2 only)
Optional System Extension:





RS232/RS422 Port: via internal factory mounted and configured RS232/RS422 adapter module
CAN Port: via internal factory mounted CAN adapter module
DVI-D Port (single Link) or DisplayPort (via corresponding internal factory mounted adapter modules)
Optional external accessible RTC lithium battery
Optional system extension with fan tray (not possible for KBox C-101-0)
The KBox C-101 is a fanless system with a compact aluminum chassis with cooling fins.
The rated voltage range of the mains can be found on the type label. The type label is located at the right side of the
device (Fig. 28, pos. 9).
The KBox C-101 is designed to be operated wall mounted inside a control cabinet, in vertical position,
except with the top side facing down.
When you power on the KBox C-101, make sure that the air exhaust openings on the top side
(Fig. 30, pos. 12), the air intake openings on the bottom side (Fig. 31, pos. 11) and the cooling fins of
the chassis (Fig. 29, Fig. 30 and Fig. 31, pos. 6) are not obstructed (covered) by any objects.
To provide sufficient heat dissipation via the cooling fins of the device, do not cover the cooling fins of
the KBox C-101. Do not place any objects on the device. When installing the system, please observe the
clearance recommendation (keep out area) in the subsection 11.1 “Control Cabinet Mounting”; refer to
the marked areas in Fig. 46 to Fig. 50.
www.kontron.com
19