Download OPERATING INSTRUCTIONS AND SYSTEM DESCRIPTION FOR

Transcript
ELC-01X User Manual
________________________________________________________________________________________________________________
Computer control of the mode of operation
In the EXT position of the MODE SELECT switch all MODEs OF OPERATION can be
selected by TTL signals connected to the rear panel.
Output configuration
The ELC-01X amplifier has two output BNCs for POTENTIAL and two output BNCs for the
CURRENT signal. The POTENTIAL OUTPUT FROM HEADSTAGE is a pure DC output
that monitors the electrode potential directly from the headstage. The signal at the
POTENTIAL OUTPUT can be high and low-pass filtered and amplified. The CURRENT
OUTPUT FROM HEADSTAGE monitors the current directly from the headstage with a
scaling of 0.1V/nA. The current output signal at CURRENT OUTPUT can be scaled from
0.1V/Na up to 10V/nA.
Digital displays
All ELC amplifiers are equipped with two digital displays, one for CURRENT (nA) and one
for POTENTIAL (mV) or ELECTRODE RESISTANCE (M). The mode of operation is
indicated by a row of LEDs located close to the digital displays.
___________________________________________________________________________
version 2.3
page 7