Download Assembly and operating instructions Power System Module

Assembly Instructions
EN
17.2.1. Mounting in Rittal TS enclosures,
base and roof frames
D
B
A
C
•
For retrofitting, the Rittal PSM can also be
fastened to the base and roof frames (D).
The two mounting brackets (B) from the
mounting kit must be used.
The 90°-angled brackets (B) are fastened to
the end covers at the top and bottom of the
bus bar. The bus bar (A) with the mounted
brackets is then fastened to the appropriate
roof and base frame elements using the
enclosed screws and washers (C).
Fig. 24: Installation in the TS 8 enclosure
Fig. 25: Installed PSM bus bar in the TS 8 enclosure
42
PSM
Power System Module