Download NuTone QTXEN150FLT Instructions / Assembly
Transcript
MODELS QTXEN080FLT • QTXEN110FLT • QTXEN150FLT Page 3 1b. Mount housing anywhere between trusses, joists, or I-joists using hanger bars. Slidinghangerbarsareprovidedtoallowforaccuratepositioningofhousinganywherebetweenframing.Theycanbe usedonalltypesofframing(I-joist,standardjoist,andtruss construction)andspanupto24”. 2. Attach damper/duct connector. Snapdamper/ ductconnector ontohousing. Makesureconnectorisflushwith topofhousingand damperflapfalls closed. TAB SCREWS(4) 3. Install 6-inch round ductwork. ST D Connect6-inch roundductwork todamper/duct connector.Run ductworktoa roofcaporwall cap.Tapeall ductworkconnectionstomake themsecureandairtight. MOUNTING CHANNEL(2) HANGER BAR(4) Attach the MOUNTING CHANNELS to the housing using theSCREWSsupplied.MakesureTABSface“up”asshown. Usethesetofchannelmountingholes(marked“STD”)to mountthehousingflushwiththebottomofthedrywall.Use the other set of holes (not marked) to mount the housing flushwiththetopofthedrywall. HOLEFOROPTIONAL SCREWMOUNTING(4) NAIL(4) CONNECT WIRING *SCREW(2) BOTTOMEDGE OFFRAMING ExtendHANGERBARStothewidthoftheframing. Hold ventilator in place with the hanger bar tabs wrapping aroundtheBOTTOMEDGEOFTHEFRAMING. NAILventilatortoframingorfastenwithscrews(notprovided) throughHOLESnearnails. Toensureanoise-freemount:Securehangerbarstogether *with SCREWS or use a pliers to crimp mounting channels tightlyaroundhangerbars. 4. Connect electrical wiring. Run120VAChousewiringtoinstallationlocation.Use properULapprovedconnectortosecurehousewiringto wiringplate.Connectwiresasshowninwiringdiagrams.
This document in other languages
- español: NuTone QTXEN150FLT