Download Tonka Dig n Go Construction none User's Manual

Transcript
- S A N D SIFTER BRIDGE -1. Fit sad
-%WiNh
.
n,
-
h
W
-
I
U~?X~~'~IPE
STl)i?A66 PANEL
1I
fo .o ,s)Dq( p n e i Into posit~&hsnlokn. Uslng
fiG @r,wup 81r
e np with
viics'as (ihj
NPI :Hinge
sCre+@in~1s tbsignr!
open
2. Fit rain pipe into position shdin. Usiig
P h i t j c e y riyer, (pure in place witti$vd
v i8;1-4 J : r . .?
;j4
- .~fiPiA.
*r
I
1
7
4
1
It
.
r i
I
(.:
,
-
,e
3. Fi
ivw
7
,
1 'I
and clow'tb stbm sand dnd atcbssbties.
t shovel
atm hrisAele ss shown-wet).
, .
I
I
1
I \
l
1
A X L E / W H ~ ~ ~ ~ ~ ' ti&
&@
.a* ""sf%~.*h
5. Push whe?mqt#,#h&I
p i t h rim MI( out as
at w o n wheat
l Y con.
the alFiched w s h nut)
heel insert and through
'
axle sleeve.
AXLEIWHEEL ASSEMBLY CONT.
AXLEIWHEEL ASSEMBLY CONT.
GUARORAILSIRETAINER WALLS
7. Push axle lhrough axle hole and
continue pushing all the way through the oppo.
site end.
0. Slide the other axle sleeve over end 01 axle then slide
9. The lour guardrails and two retainer walls can
be inserted and removed from holes as shown.
the olher wheel (with wheel Insert) over end ol axle
as shown. Hold product on its side and secure wheel
in place with push nut as instrucled in Step 14.
rat rcc.m:at #a:ir~ tk sp~sb~htti
07 I
ML: ti m
do
. .
'
,In7 p l N m nd3:r kbs h m s r ~ l
SHOVEL ARM SCOOP
A
GRIPPER CLAWlLlFT
SHOVEL ARM
STORAGE & PORTABILITY
10. Guide the upper gripper claw piece through the
lower gripper claw piece and snap slots onto
the lower gripper claw bar. Snap the lower lift's
slots onlo the upper lift's bar as shown.
11. The handles ol the gripper claw, lift and
shovel arm scoop all fit inlo the hole at end o l
shovel arm. Make sure the rounded areas o l each
piece match the rounded area of shovel arm
betore inserl.rg To remove ezch p m e , press
re ease bunon and p. p ece out. Each p ece can
also be uscd as a hand-held accessory!
12. Fil lhe dump truck, guardrails. relainer walls.
dinosaur "fossil" and constructlon cones under the
storage panel and close panel. (Sand can also be
stored here.)
STORAGE & PORTABILITY CONT.
STORAGE & PORTABILITY CONT.
13. \'11!h the shovel arm scoop inserted into lhe
shovel arm. lit the handles of the gripper claw
and lilt into holes in shovel arm as shown.
14. Fit the end of shovel arm inlo drain plpe as shown (FIG I). then guide the shovel arm below storage pan.,
until it's secured in place (FIG 2). The sand hopper fils under shovel arm. Now you're ready to roll!
'
P r m w l ard L Cmdy
I~
vary
~S
1536 Haibro. Inc Pawluckrt. R h m r 11'1.10 02362 i l l R y h l i R e r c v z j
MADE IN USA. DUMP TRUCK W E IN CHINA.
92?<5
P:N4621203
.