Download Quantum vmPRO 4000 User's Guide

Appendix 1: vmPRO CLI Guide
vmPRO Console Commands – net
net hosts show
Use to display all hosts for your network.
net nslookup <hostname | IP_address>
Use to check for DNS-to-IP or IP-to-DNS mapping. Use this command for debugging network problems.
net ping <hostname>
Use to confirm a connection between the vmPRO appliance and a host.
net reset
Use to reset network service.
net set hostname <hostname | IP_address>
Use to set a host name or IP address for the vmPRO appliance.
net show config [all]
Use to display the current network driver settings for the Quantum vmPRO Ethernet interface.
net show dhcp
Use to display Dynamic Host Configuration Protocol (DHCP) details.
net show hostname
Use to display the current host name used by the vmPRO appliance.
net show routes
Use to display all entries in the IP routing table.
net show status
Use to display network statistics, including live connections.
net tcpdump start [<tcpdump argument> ...]
Use to begin a tcpdump that writes output to a file similar to tcpdump.2010-09-20.09-54.log.
Any valid arguments for the tcpdump command can be used.
Example
net tcpdump start -c 100 executes tcdump -c 100
You can run only one tcpdump at a time.
Quantum vmPRO User’s Guide
218