Download Quantum vmPRO 4000 User's Guide
Transcript
Appendix 1: vmPRO CLI Guide vmPRO Console Commands – ntp net tcpdump stop Use to stop a running tcpdump, and print the file to which the data was being written. Output files for tcpdump commands cannot exceed 8 MB. If a single tcpdump file reaches 8 MB in size, the system automatically stops running the command. Older tcpdump log files are deleted to make room for new ones. vmPRO Console Commands – ntp Use ntp commands to configure and monitor the list of Network Time Protocol (NTP) servers that your vmPRO appliance can use to control its internal clock. In addition, use ntp commands to activate and deactivate NTP service for your vmPRO appliance, as well as to sync the appliance with its NTP server. ntp commands ntp add <server> Use to add a time server to the list of available NTP servers. ntp del <server> Use to delete a time server from the list of available NTP servers. ntp disable Use to deactivate the NTP service for your vmPRO appliance. ntp enable Use to activate the NTP service for your vmPRO appliance. ntp reset Use to read through the list of time servers, and to identify changes to the list of servers. ntp show Use to display the list of time servers available to your vmPRO appliance. ntp sync Use to synchronize your vmPRO appliance with its assigned NTP server. Quantum vmPRO User’s Guide 219