Download Philips WV-NM100 User's Manual

How to Operate
If the preparations have been completed, you can begin the operation from the "Basic setup" page.
Screenshot 1
Begin the operation from the "Basic setup" page.
STEP1
Click the [Control] button.
STEP2
Screenshot 2
The "Control" page appears.
Notes
• If the preparations have been completed, start up the
browser and display the "Top Menu" page of the desired
camera. The camera picture appears on the "Top Menu"
page.
• The port number for the MPEG-4 streaming is set to
5004. If another application uses this port, change the
port number to another even-numbered port number.
• To switch the currently monitored picture to another camera picture, click the [STOP] button to stop displaying the
currently monitored picture. Then, enter the IP address of
the desired camera in the "Address" box of the browser to
monitor the desired camera picture.
35
To display the motion picture of the selected
camera, click the [Live-ON] button.
To quit displaying the motion picture of the
selected camera, click the [STOP] button. The
motion picture disappears.
On this page, you can also operate the camera
and adjust the motion picture.
Panning and tilting
Click the arrow buttons (up / down / right / left) to
adjust the horizontal and vertical position.
The center of the box surrounded by the arrow
buttons (the point where the horizontal line and
the vertical line cross) is the current position of
the camera.
If you click inside the box surrounded by the
arrow buttons, you can pan and tilt the camera
wider than by clicking the arrow buttons.
Image capture size
Click one of the motion picture resolution buttons (CIF (352 x 288) / QCIF (176 x 144)) to display the motion picture with the desired resolution.
Adjustment of the brightness of the motion
picture
Click the buttons to adjust the brightness of the
motion picture. The left end button (–) is the
darkest and the right end button (+) is the brightest. The green button is the currently selected
level.
Image size
Click one of the buttons (x1.0 / x1.5 / x2.0) to
select the desired motion picture size.
When the picture is magnified, the quality of the
picture may be decreased.
AUX
Click one of the buttons (High/Low) to set the
status of the AUX output connector. (Refer to p.
53 for details.)
One time pan
You can monitor the picture by panning the
camera one time to the left and right.