Download Miele F 1471 Vi Specification Sheet
Transcript
Product and Cut-out Dimensions F1471Vi 84" 25" m in. 4" 17 3/ 24" EPTS ACC M T I N U STO A CU PANEL NT FRO O 18" 83 1/2" - 85 3/8" W E E - 5 foot - 120 Volt - 15 Amp 3-wire molded plug power supply connects lower left rear. O - Standard NEMA 5-15 Outlet - locate less than 9" above finished floor W - 1/4" flexible water line - tape to floor 1 1/4 " 4 1/8 " 6 5/8" - 8 1/2" Location Codes 2" - 8 3/8" 9 1/2 " Notes • All Installations must be done in accordance with local codes • Sides of adjoining cabinets should be filled (flush to frame) to insure proper fit and finish NOTE: Drawing is not to scale. SPECIFICATION SHEETS 150209 Product and Cut-out Dimensions F1471Vi Dispenser location Hinge 1/2" - 2 3/8" 42 13/16" 14 1/2" 9 1/16" Hinge Centerline Notes Notes • Centerpoint is 43 13/16" with typical 84" installation • All Installations must be done in accordance with local codes NOTE: Drawing is not to scale. SPECIFICATION SHEETS 150209 Front Panel Information Fully Integrated Model Custom Panel Installations These units do not come equipped with a front panel. They are designed to accept a custom door panel supplied by the cabinet maker. Miele has a unique panel integration system which allows the panels to align with the surrounding cabinets. Panel size is determined in the following manner: Width: 17 3/4" in all cases Thickness: Minimum 3/4" outside frame Miele Fully Integrated Freezer Panel Height = HOC - TKH HOC = Total height of cabinet or side panel TKH = Toe-kick height HOC Panel Height Height: Determined using the following calculation: Note: Finish back side of panels to insure appearance Panel may extend above unit. This is not considered in height calculation Maximum hinge capacity: 200 Pounds Maximum panel weight: 134 Pounds TKH Panel Notes If the adjoining cabinets are taller than the height of machine (HOM) - the front panel may be extended accordingly. Simply maintain the toekick height and extend the panel the needed distance. Adjoining cabinet Extended Panel Machine NOTE: Drawing is not to scale. SPECIFICATION SHEETS 150209 Front Panel Information Hinging Details 90° Door 115° Door Thickness options Thickness options 0-1/8" 0-1/8" 0-3/4" 1" 1-1/4" 1-1/2" 1-3/4" 0-3/4" 1" 1-1/4" 1-1/2" 1-3/4" 2" Cabinet Front Cabinet Front 1" Fro nt P ane l 0-3/4" 1-1/2" 1-1/4" 1" 1-1/4" Front Panel 0-3/4" 1-1/2" Door Swing Door Swing 7 1/4" MAX 20 11/16" 7/16" NOTE: Additional space needed depending on the thickness of front panels and handle used. Freezer units cannot be stop pinned at 90° NOTE: Additional space needed depending on the thickness of front panels and handle used. Freezer units cannot be stop pinned at 90° NOTE: Drawing is not to scale. SPECIFICATION SHEETS 150209