Download HP StorageWorks Edge Switch 2/16 User's Manual

Product Manager Messages
Table A–1: HP StorageWorks Edge Switch 2/16 Product Manager Messages
Message
Description
Action
Cannot set switch state.
Switch state cannot be set.
The link is down or busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot set write
authorization without
defining a community name.
A community name was not
defined in the Configure
SNMP dialog box for the
write authorization selected.
Provide a name in the name
field where write
authorization is checked.
Cannot start data collection.
Data collection cannot be
started. The link is down or
busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot start port
diagnostics.
Port diagnostics cannot be
started. The link is down or
busy.
Retry the operation later. If
the condition persists,
contact support personnel.
Cannot swap an uninstalled
port.
A port swap cannot be
performed when the port is
not installed.
Perform a swap only on a
port that is installed.
Click OK to remove all
contents from log.
Requesting confirmation
that you want all contents
removed from the log.
Click OK to continue or
Cancel to cancel the
operation.
Continuing may overwrite
host programming.
Continue?
Configurations sent from the
host may be overwritten by
HAFM.
Continuing will activate the
current configuration, which
may have been configured
by an S/390 host.
Could not export log to file.
A file I/O error occurred. The
log file could not be saved to
the specified destination.
Ensure filename and drive
are correct.
Could not find firmware file.
Firmware file selected was
not found in the FTP
directory.
Ensure file name and
directory are correct.
Could not find firmware file.
The selected file is not a
firmware file.
Obtain a valid firmware file
from your service
representative.
edge switch 2/16 product manager user guide
A–5