1
Download HP SN6000 Command Reference Guide
Transcript
cfgEnable 2 cfgEnable Enables a zone configuration. SYNOPSIS DESCRIPTION cfgenable "cfgName" Use this command to enable a zone configuration. The command builds the specified zone configuration. It checks for undefined zone names, zone alias names, or other inconsistencies, by expanding zone aliases, removing duplicate entries, and then installing the effective configuration. If the build fails, the previous state is preserved (zoning remains disabled, or the previous effective configuration remains in effect). If the build succeeds, the new configuration replaces the previous configuration. Refer to the cfgShow command for a description of the defined and effective configurations. If there are open transactions in the fabric, only single transaction can be saved. Use the cfgtransshow --opentrans command to view the list of all the domains in the fabric with open transactions. NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. When an FCS policy is enabled, this command can be issued only from the primary FCS switch. OPERANDS The following operand is required: "cfgName" Specifies the name of the zone configuration. The name must be enclosed in double quotation marks. EXAMPLES To enable the zone configuration USA_cfg: switch:admin> cfgenable "USA_cfg" You are about to enable a new zoning configuration. This action will replace the old zoning configuration with the current configuration selected. If the update includes changes to one or more traffic isolation zones, the update may result in localized disruption to traffic on ports associated with the traffic isolation zone changes Do you want to enable 'USA_cfg' configuration \ (yes, y, no, n): [no] y zone config "USA_cfg" is in effect Updating flash ... To enable the zone configuration USA_cfg when there are open transactions in the fabric: switch:admin> cfgenable "USA_cfg" You are about to enable a new zoning configuration. This action will replace the old zoning configuration with the current configuration selected. If the update includes changes to one or more traffic isolation zones, the update may result in localized disruption to traffic on ports associated with the traffic isolation zone changes Multiple open transactions are pending in this fabric. Only one transaction can be saved.Please abort all unwanted transactions using the cfgtransabort command. Use the cfgtransshow --opentrans command to display a list of domains with open transactions Fabric OS Command Reference 53-1003108-01 109
