Download Barco LR-6 User's Manual

4. Setup
Image 4-2
1
Function keys
user programmable keys with functions for direct access.
2
MENU
Menu key, to enter or exit the Toolbar menu.
3
Address key
(recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
4
LOGO key
allows to recall the stored Logo (not in PiP mode)
5
PAUSE
to stop projection for a short time, press ’PAUSE’. The image disappears but full power is
retained for immediate restarting.
6
STBY
standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to go
to standby, press the standby key for 2 seconds.
7
MUTE
to interrupt the sound reproduction (audio = optional.
8
AUTOIMAGE
Auto image, to center the image on the active LCD surface.
9
Digit buttons
direct input selection.
9b
SOURCE button
this button allows to switch through the active (scanned) inputs
10
Lens control
use these buttons to obtain the desired ZOOM, SHIFT, FOCUS.
11
VOL
use this button to obtain the desired sound level (audio = optional)
12
Picture controls
use these buttons to obtain the desired picture analog level.
13
DIGI ZOOM
allows a digital Zoom of a part of the image
14
FREEZ
press to freeze the projected image.
15
PIP
allows to activate the PICTURE IN PICTURE mode
R59770134 ID LR-6 27/05/2011
27