Download Avaya Configuring BOOTP Services User's Manual

Configuring SNMP, BootP, and DHCP Services
Parameter: DLCI Number
Path: Configuration Manager > Protocols > IP > BOOTP > Relay Agent Interface
Table > Client I/F > Add
Default: None
Options: 16 to 1007
Function: Specifies the frame relay PVC identification number whose destination is the
remote AN that will boot using EZ-Install. The frame relay network uses the
DLCI number to direct data flow.
Instructions: Enter the DLCI number, in decimal format, for the group access PVC to the
remote AN. Use the DLCI number assigned by your frame relay service
provider.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.1.1.1.2
BootP Preferred Server Configuration Parameters
Use the following guidelines to configure BootP and DHCP preferred server
configuration parameters.
Parameter: Relay Agent IP Address
Path: Configuration Manager > Protocols > IP > BOOTP > Relay Agent Interface
Table > Pref Serv > Add
Default: None
Options: Any valid IP address
Function: Specifies the IP interface that receives BOOTREQUEST or DHCP packets from
clients.
Instructions: Enter the IP address of a numbered network interface that you want to receive
BOOTREQUEST or DHCP packets from clients, and then configure this IP
address on the router, if you have not already done so.
Do not specify an unnumbered interface for this parameter.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.3.3.1.3
A-22
308644-15.1 Rev 00