Transcript
ORBIT™ UNDERCOUNTER SINK VITREOUS CHINA BARRIER FREE ORBIT™ UNDERCOUNTER SINK • Round undermount sink • Made from vitreous china • Front overflow • Unglazed rim for undercounter mounting • Supplied with mounting kit (047194-0070A) and template ❏ 0630.000 Sink less faucet deck Nominal Dimensions: 394mm dia. (15-1/2") Round Bowl sizes: 324mm (12-3/4") wide 111mm (4-3/8") deep Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M for Vitreous China Fixtures • CAN/CSA B45 series 2" (51mm) MINIMUM 76mm (3) FINISHED WALL OR SPLASHBACK 1-1/4" DIA. C.H. (TYPICAL) 610mm (24) 2-1/2" (64mm) EDGE OF COUNTERTOP CUTOUT 7-5/8" (194mm) CUTOUT AREA 203mm (8) MIN. 15-1/2" (394mm) 864mm (34) 45o 1-3/4" DIA. STD. DRAIN OUTLET DRAWING FOR DIMENSIONAL PURPOSES ONLY. IT IS NOT AN EXACT REPRESENTATION. 686mm (27) MIN. MTG CLIP (4 PLACES) 152mm (6) MAX. 15-1/2" (394mm) COUNTERTOP (BY OTHERS) 5/8" (16mm) SEALING COMPOUND BARRIER FREE CLEARANCE 229mm (9) MIN. 6" (152mm) *10-3/4" (273mm) *12-7/8" (327mm) DETAIL OF MOUNTING CLIP (KIT No.47194.0070A) 31" (787mm) SUGGESTED SUPPLIES AS REQ'D 8" (203mm) BRASS INSERT 34" (864mm) 1-1/4" O.D. WASTE 19mm (3/4) MIN. LAVA 1-1/4" O.D. TAILPIECE FINISHED FLOOR CLIP MACH. SCREW To Be Specified: ❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Fawn Beige ❏ Black ❏ Faucet*: ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap: * See faucet section for additional models available MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 ACCESSIBLE AND USABLE BUILDINGS AND FACILITIES CHECK LOCAL CODES. Countertop 864mm (34") from finished floor. Lavatory installed 51mm (2") MIN. from front edge of countertop. Countertop thickness to be 25mm (1") maximum. © 2008 AS America Inc. FITTING A B CENTER-SET 27mm(1-1/16) 102mm(4) SPREAD 32mm(1-1/4) 203mm(8) REFER TO INSTRUCTIONS PROVIDED WITH KIT FOR ADDITIONAL INFORMATION NOTES: DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE *SUGGESTED. ▼ UNDERCOUNTER MOUNTING KIT SUPPLIED WITH SINK. FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. USE ENCLOSED TEMPLATE FOR COUNTERTOP CUTOUT. SEALING COMPOUND SUPPLIED BY OTHERS. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages. J51 Revised 2/08
