Transcript
LOFT™ ABOVE-COUNTER SINK VITREOUS CHINA LOFT™ ABOVE-COUNTER SINK ❏ 0660.000 •Stylish above-counter sink •Made from vitreous china •Integral faucet deck for single-control faucet mounting • Generous bowl depth • Center drain outlet without overflow • Can be mounted in Brook console table • Supplied with cutout template and sealant ❏ 0660.312 Same as above with front overflow Nominal Dimensions: 451mm (17-3/4") Round Bowl sizes: 376mm (14-3/4") round 127mm (5") deep FINISHED WALL OR SPLASHBACK 35mm (1-3/8) DIA. HOLE 83mm (3-1/4) 123mm (4-7/8) Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M for Vitreous China Fixtures • CAN/CSA B45 series • A1995 National Building Code, section 3.7 and CAN/CSA - B651-M90 and OBC 3.7 OPTIONAL 222mm (8-3/4) 286mm (11-1/4) C/L COUNTERTOP CUTOUT 330mm (13) DIA. ø376mm (14-3/4) To Be Specified: ❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Black ❏ Faucet*: ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap: ø451mm (17-3/4) SEALING COMPOUND COUNTERTOP (BY OTHERS) 76mm (3) 95mm (3-3/4) *165mm (6-1/2) To Be Specified (Optional): ❏ Brook Console Table Frame 9373.100 ❏ Frame Finish ❏ Brook wood top 9474.670 pre-cut for Loft and Morning above counter sink ❏ Wood Top Finish *222mm (8-3/4) SUPPLIES AS REQ'D 203mm (8) 1-1/4 O.D. WASTE 178mm (7) 787mm (31) 1-1/4 O.D. TAILPIECE * See faucet section for additional models available FINISHED FLOOR NOTES: DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE *SUGGESTED. FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE TEMPLATE SUPPLIED WITH SINK. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages. © 2008 AS America Inc. J18 Revised 2/08
