Download Benq MX662
Transcript
5.3 Module Assembly Assembly Key Point - Optical Engine 1. Light Pipe Module assembly and overfill alignment 1.1 Assembly LP Module to HSG DMD i. ii. iii. Assembly “Clip LP” and lock with screw well (Fig. 1-2). Press CLIP of RE_BKT_LP first, and then push it into the hole (Fig. 1-3). Placed LP Module on LP datum of “DMD HSG” and adjustment screw well, shown(Fig. 1-4). iv. v. Assembly “Baffle LP” first (Fig. 1-5) & push “Baffle LP” to hook DMD HSG(Fig. 1-6), When Lock the screw of Baffle LP ,the hand must push the left corner of Baffle LP before (Fig. 1-7),. vi. vii. Lock the screw of Baffle LP well then release the hand (Fig. 1-8), Assembly two Overfill adjustment screws (M2, 8L) to HSG DMD (Fig. 1-1). ** Adjustment criteria refer to below item 1.2 1.2 Overfill Adjustment @ LP Module Overfill Adjustment Criteria: i. ii. Pre-assembly 2 adjusting screws. Alignment Sequence: a. To adjust “Horizontal Adjustment Screw” firstly, and then “Vertical Adjustment Screw”. (Based on production line condition, OE could change the sequence) 1.3 For Overfill Re-adjustment: a. Loosen two adjustment screws b. Follow adjustment steps shown in Item 1.2-ii. Overfill Vertical Adjustment Screw M2, 8L Overfill Horizontal Adjustment Screw M2, 8L Fig. 1-1 80