Download AMX NXT-CV10

Firmware Pages and Descriptions
Certificate files frequently use 5 file extensions. It can be confusing because there is not a one to one
correspondence. The following table shows the possible file extension used for each certificate type:
Certificates and their Extensions
Certificate Type
Possible File Extensions
PEM
.cer
.pem
.pvk
DER
.cer
.der
PKCS12
.pfx
It is important to note which certificate types are supported by the different certificate fields used on the
configuration screens (PEAP, TTLS, and TLS). The following table outlines the firmware fields and their
supported certificate types.
Certificate Types Supported by the Modero Firmware
Configuration Field Name
Certificate File Type Supported
Certificate Authority field
PEM and DER
Client Certificate field
PEM and DER
Private Key field
.PEM, DER, and PKCS12
System Settings Page
The System Settings page (FIG. 114) sets the Secondary DNS Address information with its corresponding IP
communication parameters, NetLinx Master communication settings, and reads the device number assigned to
the Modero panel.
IP Settings section
Master Connection section
(NetLinx Master properties)
Master Connection features do not take
effect until the panel is rebooted
Red fields are user-editable
Blue fields cycle through choices
Grey fields are read-only
FIG. 114 System Settings page showing default values (reads and assigns values to the panel and Master)
The elements of the System Settings page are described in the table below:
System Settings Page Elements
Back:
Saves the changes and returns you to the previously active touch panel page.
Connection
Status icon:
This visual display of the connection status allows the user to have a current visual
update of the panel’s connection status regardless of what page is currently active.
• A Lock only appears on the icon if the panel has established a connection with a
currently secured target Master (requiring a username and password).
IP Settings:
DHCP/Static
Sets the IP communication values for the panel and contains:
Sets the panel to either DHCP or Static communication modes.
• DHCP (Dynamic Host Configuration Protocol) assigns IP Addresses from client stations
logging onto a TCP/IP network via a DHCP server.
• Static IP is a permanent IP Address that is assigned to a node in a TCP/IP network.
IP Address
10" Modero Touch Panels
Sets the secondary IP Address assigned to the panel.
127