1
Download Zebex Z-1170-BT
Transcript
3.5.3. RF Device – PDC as Slave Select RF Device Select 2. Slave Mode Previously PIN is shown. The left communication parameter is same as RS-232 setting. 3.5.4. RS-232 Cable Select RS-232 Cable Disable/Enable Sequential Num. Press SCAN to select Disable/Enable Checksum Digit. Press SCAN to select Disable/Enable STX/ETX Packet. Press SCAN to select If enable STX/ETX you will asked set Add Terminator. Select Data Terminator. Press SCAN to confirm 26
